Farmall & IHC Tractors Discussion Board |
Re: Bleeding air from Farmall 400 hydraulic system
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JayWalt on December 12, 2006 at 17:28:46 from (24.223.138.48):
In Reply to: Bleeding air from Farmall 400 hydraulic system posted by Duanes on December 12, 2006 at 14:57:44:
On my 300u the lift rams would not bleed themselves by cycling. So What I had to do is this: removed one of the rams, leaving the hose connected. Then use the tough control to extend the ram all the way out. Then while having the touch control in the down postion (these are one way cylinders), turn the cylinder so the hose is up in the air, then manually push the ram back in. The air will rise to the top where the hose is and when you push the ram in it will push the air through the hose and into the resevoir. I did this 2x on each cylinder, now no more bouncy loader. For the dump cylinders which are 2 way, I just cycled them like 5 times, as well as the hitch lift cylinder.
Replies:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|