Farmall & IHC Tractors Discussion Board |
Re: OT/Vintage Spoked Wheel Axle ID
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Ron in Nebr on December 01, 2006 at 08:34:29 from (66.252.114.8):
In Reply to: OT/Vintage Spoked Wheel Axle ID posted by Kendog on December 01, 2006 at 06:45:23:
With the conflicting Chevy/Ford stampings, it's hard to tell for sure just based on written description....although I'd bet a nickle they're Ford. If you have pics, posting them on here would be a good plan. Also- check out the axle(s). If the have a single vertical(up and down) hole through them about 8 inches in from the hub on each side, they're most likely Ford. Ford was also really good back in the day to have the word "FORD" cast into most parts.... Chevy axles would have a flat pad for paralell(sp) leaf springs(two springs per axle running the same direction as the frame rails) to mount with 4 bolt holes in it.
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|