Farmall & IHC Tractors Discussion Board |
Re: Super C power
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by gene bender on November 25, 2006 at 03:23:02 from (67.55.226.214):
In Reply to: Super C power posted by Chris from Wa on November 24, 2006 at 11:57:55:
All of the C blocks could take increased bore with domed pistons same with SUPER Cs Problem is which bore are we wishing to go to. You can go to 3 1/8 or even 3 1/4 depending on which block you have some have even tirned sleeves down where the o-ring goes to add larger dia sleeves. You need to pull a sleeve to see for sure what that dia realy is as you have an old tractor and no way of knowing if block has been changed thats why i would pull a sleeve then measure and go from there. There was a post on here not to long ago that had ordered a kit and not knowing facts installed rings on the pistons then discovered that he had wrong sleeve and how do you return a kit that has rings on the pistons so save some greif and pull a sleeve and measure then proceed.
Replies:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|