Farmall & IHC Tractors Discussion Board |
Question for Bernard le Mechano
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Fromjb2 on November 04, 2006 at 18:04:08 from (69.198.143.165):
Hi Bernard, my brother bought a CIH 3230 at an auction sale last week. Today we tried moving his 2250 loader from his CIH 495 to the 3230, the frame was OK but we ran into problems with the hydraulic connections. On the 495 the pressure line came out of the front top port of the control valve for the rear remote hydraulic outlets and the return goes back in the drain plug under the right rear axle. On the 3230 the control valve for the rear hydraulic outlets already has a steel hydraulic line going into the front port but the rear port has a plug in it but you cannot screw a 90 elbow into it as the steel line going to the front port is to close to the rear hole. You also cannot install a straight pipe as there is no clearance from the seat deck. Questions: 1) Can we just plug the pressure port on the 495 or will there be no where for the hydraulic oil to go but trip the relief valve? 2)How is the correct way to connect the loader control valves from a 2250 loader to a 3230? Merci JB2
Replies:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|