Farmall & IHC Tractors Discussion Board |
Speaking of Generators......
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by sstractoranch on October 28, 2006 at 12:56:25 from (71.105.43.123):
Hello, I have recently posted about the charging system project on my H, Got it up and going thanks to the help here. After getting it to work, The adjustable pulley on the gen was froze so I had to pull it away from the engine and tighten lower mounting bolts to hold it in place. After installing a good adjustable pully (thanks cowman), I have the gen mounted in its proper fixed position, and the belt (a new replacement) tensioned what I think is correct. Now with the engine at Idle the amp meter is at 0, and with the lights on it drops to about - 10. When I bring up the rpm the amp meter comes up toward the 0 again, but it has to be at full throttle to get to 0. Apparently the belt running in the larger diameter of the pulley made quite a difference in the output of the generator. It seems if the gen was working properly, this would not be a problem, Should I have the gen checked again,or get a shorter belt so the pulley could be opened up a little deeper? Is there any adjustment in the regulator? Or could my battery be questionable, it did sit for a long time, but it charged up and started the tractor many times before I put the gen back on. Questions, Questions, Questions....Tom
Replies:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|