Farmall & IHC Tractors Discussion Board |
how to install pilot shaft and clutch release bear
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bill Zuke on September 22, 2006 at 15:56:12 from (205.188.116.133):
Okay, I got my clutch out of my M. After I followed all the steps on this site and others, it came out in a dramatic fashion, and that's fine. I now neeed to replace the clutch and have all the parts. I think I need help figuring out how to install the pilot release bearing (I have it in and and the orientation doesn't seem to matter). I have read that it goes in the flywheel, I suppose in the center, and needs a smidge of grease. I am not sure it came out when all else fell out two days ago. I don't remember seeing anything the size of what I just got in the mail. With regard the the clutch release bearing, I think I generally know where it goes on the shaft because the remnance of it are still there. But it looks like a pressed in sort of bearing which must turn one way or the other. One side is flat and has a lip on the outside diameter. The other side has the bear rings exposed with the grease. Which way does this face oon the shaft? It may be obvious when I get out there, but maybe not. Bill
Replies:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|