Farmall & IHC Tractors Discussion Board |
Re: 1066 Torque Range
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by IaGary on September 10, 2006 at 05:47:23 from (69.63.5.240):
In Reply to: 1066 Torque Range posted by Rick in Ont. on September 10, 2006 at 05:10:55:
Rick By turning up the fuel and the rpms that 414 motor is able to go over 400 hp. I would not run that way very long but they will do it. Had the flow needle go bad on my 1086 (414 motor) and didn't know why it was smoking so bad. When we put it on the dyno it had over 300 hp. I was plowing at night when it happened so I ran it that way for a few hours without knowing. About 2 months later I had to put a head gasket in the 1086. Hmmmm I wonder why it went bad. Yes it will burn more fuel when you turn up the fuel or RPM's. You can run those 414 safely at 180 HP but if you don't need it don't do it for economy reasons. Gary
Replies:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|