Farmall & IHC Tractors Discussion Board |
Re: One more time please! I need 2 parts and help
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Red Dave on August 31, 2006 at 11:05:19 from (24.104.94.34):
In Reply to: Re: One more time please! I need 2 parts and help posted by Patrick Martin on August 31, 2006 at 10:42:08:
Inspect everything for wear and tear. Look at the pins that the flyweights are on and check them for sloppy fit. Make sure the balls on the thrust bearing are free, no wear or corosion. Check all the springs, replace any that show wear. That big main spring that pulls the throttle open has been known to break and let folks sit with no more than an idle. If it shows any wear at all, I'd put one in it. Check the rockshaft bushings and seals. Everything in that governor needs to move freely, but without slop. Too much wear can make the governor act erratic. My main message is that once you have it apart, it is very little trouble and not a lot of expense to go over it while you are in there anyway.
Replies:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|