Farmall & IHC Tractors Discussion Board |
Re: biger pistons how
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by in-a-bind on July 13, 2006 at 00:29:31 from (170.93.140.8):
In Reply to: biger pistons how posted by Baxter on July 12, 2006 at 17:41:22:
Sleeves are not too hard to install in a M engine. I pulled a set using a OTC sleeve puller, and reinstalled the new sleeves after letting them sit in the frezzer for 24 hours. Make sure that your wife don't see them in HER FREZZER, or you may hear some stuff. Just use a hone with a medium grit stone to lightly scratch the surface of the new sleeves. Don't forget to retorque the head bolts after a few hours of running time. When I rebuilt mine I used the 4 1/8 inch firecrater type pop up pistons, and they sure made a world of difference between them and the standard flat top pistons that I removed from it.
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|