Farmall & IHC Tractors Discussion Board |
One more for Bob M
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Jimer on July 11, 2006 at 19:19:42 from (198.174.213.208):
Re 12 v conversion on 300u. I got your diagram, and tonight I traced all the wires with a ohm meter. Finally found them all, the last one took about an hour. It is the one from the alternator to the ignition switch, which was broken off and disconnected. Before it appeared to be charging a few amps, and discharging a few amps with the lights on. Put it back together and started it up, holy buckets the amps jumped to +45 then came down to about 35 when I stopped it. But, stopping it wasn't quite right. Could not do it with the ignition switch. If I remember right, I need to install a diode in the wire from the alternator to the ignition switch, is that right? The only difference I saw between the schematic you provided and my tractor is that my lights get power from the alternator post instead of the amp meter. Please advise on the diode, and thank you for all the help!
Replies:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|