Farmall & IHC Tractors Discussion Board |
Re: 400 throtle ajustment
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JANICHOLSON on June 27, 2006 at 21:00:36 from (134.84.102.134):
In Reply to: 400 throtle ajustment posted by budaa on June 27, 2006 at 11:14:58:
Budaa, It is quite common for the linkage to act like that. The issue is whether it is wide open, when in the last notch. (do this with tractor off) Look at the governor control lever on back of gov box. With the hand lever at idle, the gov. lever will be relaxed. Then look at it with it at full throtle on the hand lever. It should move substantially. With the hand lever in that position, disconnect the link to the gov arm. Pull the gov arm farther in that direction against its spring. If the lever will not move farther, the adjustment is OK. if it does move farther than the rod pushes it, the rod needs to be made longer (adjustments in threads) so that it is moved all the way to its stop. The wide open condition is regulated in the governor, not the link, so do not worry about overspeeding the engine by this adjustment. (not all farmalls have the same setup, some have external links to the carb, these can cause serious overspeeding if wrong. Good luck, JimN
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|