Farmall & IHC Tractors Discussion Board |
Re: H with a cracked manifold ???
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by sde on June 11, 2006 at 20:15:22 from (69.179.7.75):
In Reply to: Re: H with a cracked manifold ??? posted by old on June 11, 2006 at 17:50:56:
I posted earlier about my attempt to weld my exhaust manifold while it was still on the tractor. Afterward I had to remove the head because of slag getting in the second cyclinder. Small amounts were found in two other cyclinders as well. Before starting it, I had used a vacuum to suck them clean. The higher heat may make some of the rusted metal flake off and get into the cyclinders. My experience, and that of Tractor Vet (from his previous posts in archives)is don't weld it while on the tractor. Yours differs from mine in that you are going to weld the exterior while I tried to weld into the exhaust pipe opening.
Replies:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|