Farmall & IHC Tractors Discussion Board |
Re: Farmall M what next
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Janicholson on May 09, 2006 at 13:05:07 from (199.17.6.175):
In Reply to: Farmall M what next posted by sccwells on May 08, 2006 at 20:28:42:
The corrosion of the aluminum piston can expand so much that it puts drastic pressure on the cylinder wall, locking the sleeve in the cast bore beyond its press fit. I would buy or borrow, or make up, a fly cutter (machinist term for a one cutter hole cutter with a short blank center locater that goes in a drilled hole in the center of the piston). It would be 1/8" smaller than the bore diameter. I would machine away the top ring land (and remove the top of the piston). Once the top is removed, there will be no center hole to use, but a saws all should be able to cut out to the back of and through the remaining compression piston rings, cast iron is easy to cut. (be careful to stay parallel with the cylinder). Once the tension is off the circumference of the piston, it will move. Just my way of doing the deed. JimN
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|