Farmall & IHC Tractors Discussion Board |
Re: 400 runs
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Dave Slater on April 27, 2006 at 18:17:18 from (152.163.100.65):
In Reply to: 400 runs posted by super99 on April 27, 2006 at 17:25:14:
If you have all the linkage as close as you can get it to specs and it still hangs in gear. Go to the short rod that connects main clutch shaft to T/A clutch shaft and shorten it a little at a time until it quits hanging in gear. Make sure not to shorten it so much that theres no space or movement between T/A release bearing and fingers. The bearing should not touch the fingers unless T/A lever is pulled back or main clutch realeased. I found that it helps to bolt T/A pressure with clutch plate to carrier before installing in tractor and setting the fingers to correct specs because some are not even close.
Replies:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|