Farmall & IHC Tractors Discussion Board |
Re: Off topic, shaft vs bearing ID size
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by scotty on April 20, 2006 at 06:06:03 from (199.231.49.128):
In Reply to: Off topic, shaft vs bearing ID size posted by Jimer on April 19, 2006 at 19:34:54:
Mornin Jimer, OK, here is a quick way to convert mm to english. 30 mm x .03937 = 1.1811. You had this figured out allready but thought I would post it for you. Very seldom is there much of an interference fit between the shaft OD and the inner bearing race. Usually this is a line to line fit or just slightly smaller on the shaft OD. With that being said, you would need to have .0065 removed from the shaft to accomodate your 1.1811 inner race. Hope this helps! scotty
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|