Farmall & IHC Tractors Discussion Board |
Re: Lift pump
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Magman on March 28, 2006 at 18:26:08 from (152.163.100.65):
In Reply to: Lift pump posted by RSK on March 28, 2006 at 14:39:23:
I dont know what you have when you say the rubber hydraulic fittings . The pump is a gear driven pump with round steel balls that hold the pressure. How about the fitting that runs the pump from the tranny are both pins in it and hooked up right? The clutch deal is becuase it runs off the tranny and its always running when the clutch is out and when you push the clutch pedal down it disingages the pump. You may have a broken tooth on one of the gears inside I supose or there is a rubber mount in the clutch housing in the center of the drive shaft maybe thats ripped or bad also. Just a few things I can think of to check JON
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|