Farmall & IHC Tractors Discussion Board |
Re: 450D wheel bearings
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by the tractor vet on March 01, 2006 at 06:45:37 from (66.202.111.116):
In Reply to: 450D wheel bearings posted by Bill46 on March 01, 2006 at 04:57:01:
Yea they do have a tendency to Stick on the spindel and the way i get them off is to use my one long stiff bladed putty knife and drive it in behind on two sides then move to a thin long chisel or you can use a bearing spliter and a puller and if it comes apart well then it is shot and ya need a new bearing anyway. Also the inside bearing is always the first to go as it is the one that catches all the dirt and dust getting past the seals and it gets ground down , SOOOooo while you are fixen the one ya just might as well do both and repalce all bearings and seals and repack , now you can cheat and drill and tap behind the spokes down into the middel of the cavity bewteen the inner and outer and install a grease fitting and keep them flushed . Stop and thing about it of what that ft. end has been put thru in her life time down thru that creek , mud holes and barnyard slop and all the dust and dirt.
Replies:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|