Farmall & IHC Tractors Discussion Board |
Re: INT 350 tractor Questions
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JimN on December 20, 2005 at 20:58:00 from (24.206.203.137):
In Reply to: Re: INT 350 tractor Questions posted by Janicholson on December 19, 2005 at 20:16:47:
Hello Thanks for the information. if the engine is stuck from sitting .how do i lossen it ?? Would i put marvels mystery oil in the spak plug holes. What are my options there ? Also if i break it in half will i be able to put clutch PP and T/Out/ bearing in and brakes if need? What about other bearings or seals in water pump Hydraulic pump and( the front end loader) How would i raise it up enough to get it on a trailer to winch it on to continue work. My first tractor as a boy on Hans Schwarten,s farm at age 5 was to bale was a 350 int Han,s is in his 90,s now and i have a fondness for this tractor Charlie L
Replies:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|