Farmall & IHC Tractors Discussion Board |
Re: 706 knock in engine after rebuild
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by the tractor vet on October 22, 2005 at 10:49:39 from (4.124.70.163):
In Reply to: 706 knock in engine after rebuild posted by fedgar on October 22, 2005 at 08:39:43:
Did you rebuild the rods ???? did you FIT EACH PISTON To THE HOLE????? by mic. the out side of the piston and checken the inside bore with a mic. ???? and did you hone the sleves with a ridge hone after you installed them ???? did you plastia gauge the bearing???? If you did not do all of the above then it could be any place . Did ya have the head rebuilt and did they get the valves set correctly in the seats some valve must stick out of the head and some valves must be resessed and with out running out in the rain and looken at the books in the truck my mind can not remember that is why i have all the books . And somebody will tell me that this is not ROCKET SICENCE but if ya want a engine to run good and last long then it is . I build every engine like a 100000 dollar racing engine and PLUM REFUSE TO DO AND IN CHASSIE
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|