Farmall & IHC Tractors Discussion Board |
Re: c113 (or late C-123)engine boring
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Stan(VA). on October 03, 2005 at 05:03:16 from (4.248.34.201):
In Reply to: Re: c113 (or late C-123)engine boring posted by Charles McNelly III on October 02, 2005 at 18:40:02:
The 1st has been together about 2 years, the 2nd I am getting running now (just put it back on the tractor). Don't recall exact numbers at the shop, wasn't bad though, less work than boring through fixed sleeves (only have an inch or two rather than full length, but setup time is probably the same for them). The tisco stepped head usually look like a rectangle a quarter inch high on top of the piston. I've seen tru-power pistons advertised on ebay that have more like two smaller squares raised from the rectangle outline. Fire craters are the original IH replacements that are very rounded with two domes and a slight dish in the center. I haven't heard of fire flow pistons. Since you don't know the pin height or volume of the various domes or steps, it's hard to do a comparison unless you have them in your hands. Stan(VA).
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|