Farmall & IHC Tractors Discussion Board |
Re: Farmall H Hand Crank
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Wayne Swenson on July 24, 2005 at 15:53:09 from (66.191.69.100):
In Reply to: Farmall H Hand Crank posted by ccairns on July 24, 2005 at 11:10:40:
The former pin was likely broken off so try punching it out. Grind or file the surface to locate the original hole. Have someone hold a large sledge hammer underneath while you use a punch from the top. If you have an acetylene torch, you could heat the end of the shaft & try punching the old pin out. If memory serves, the pin is 1/4" in diameter so you can use an old bolt to replace the broken one. Find one with a long enough center section without threads and cut it off at the correct length allowing for the crank notch. Smooth the ends so your clothing will not get torn when you brush up against it in the future. Since the bolt will be a loose fit, rough the part that will be inside the shaft with a center punch so it will stay in place when driven in place.
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|