Farmall & IHC Tractors Discussion Board |
Re: Setting timing correctly on my 44 H
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by riverbend on January 01, 2005 at 07:31:08 from (208.160.34.182):
In Reply to: Re: Setting timing correctly on my 44 H posted by tanner clark on December 31, 2004 at 17:32:29:
Once you get close to TDC on #1 with the starter, you can put the tractor in 5th gear and rock the rear wheel. If you have the plugs out, you might be able to turn it over with the fan belt. With the valve cover off, #1 will be at TDC, of the compression stroke when the pointer lines up with the mark on the pulley and both valves on the front cylinder are closed (you will be able to wiggle both rockers arms with your fingers). On some motors you can see the edge of a valve through the spark plug hole when #1 is at TDC between the exhaust and intake strokes. I have not looked lately, but seem to recall that does work for the H. If not, someone will be along to set things straight.
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|