Posted by LMack on April 03, 2009 at 19:31:17 from (74.176.38.44):
In Reply to: F-20 Fuel Line posted by tritowntb on April 03, 2009 at 15:30:47:
Even on my 200 (1956) and an earlier 1941 B I had trouble using the original fuel line fittings. Both needed fuel lines and I did not find original replacements. I used steel break lines (5/16"). The built in fitting on the break line will bolt up to the aftermarket bowl with no modifications. On the carburetor end, the original used a male compression elbow fitting for the carburetor end and a female coupling on the pipe end above the compression ring. I was not able to find that arrangement but previous post indicate that it is available. Check previous post for Fuel Lines. I just replaced the male elbow on the carburetor with a female and put the male end and the compression ring on the new fuel line. I doubt that you will be able to remove the old compression ring from the old pipe without damaging the pipe.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.