Farmall & IHC Tractors Discussion Board |
Re: IH 454 torque specs
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by El Toro on November 21, 2004 at 16:29:34 from (66.119.33.186):
In Reply to: IH 454 torque specs posted by Joe in PA on November 20, 2004 at 14:51:03:
Hi Joe, My manual doesn't cover the C157, but it covers the C152 and my manual recommends 70 ft-lbs for that engine. Always start in the center of the head when torquing and torque in both directions until you reach the last bolts, then start increasing the torque 10- 15 ft-lbs and go back to the center and go over the bolts again. Keep repeating this procedure until you reach 70 ft-lbs. I would start around 30-35 ft-lbs. PS: After you get that engine running and heated up retorque the head again check your valve lash. If you locate your manual you can increase the torque. Any IH dealer will give you that torque. Try 1-800-732-0017 and ask for farm equipment service. They're located in PA. They will even fax you copy of the torque procedure for that head. Good Luck, Hal
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|