Farmall & IHC Tractors Discussion Board |
Re: H liners
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Wayne Swenson on July 10, 2004 at 21:46:27 from (66.191.70.31):
In Reply to: H liners posted by Dale L. on July 10, 2004 at 09:56:43:
Be sure the groove in the top of the engine block is clean so the liner will not protrude too far and cause a head gasket failure. Set the liner up-side down in the groove and see if it fits correctly. As the other post explained, wrap the sleeve in newspaper and then freeze it overnight. The paper helps keep it cool while transporting from the freezer to the tractor. Have a large hammer and a block of oak or other hard wood to persuade the liner to fit in place. Do not strike the sleeve directly with the hammer. Don't get any wood slivers under the sleeve lip. Have all the tools & supplies ready before getting the first sleeve out of the freezer; you do not have much time before the sleeve warms up and refuses to slide in place.
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|