Farmall & IHC Tractors Discussion Board |
Re: Block and head milling
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Kevin (FL) on April 12, 2004 at 10:43:07 from (12.77.201.82):
In Reply to: Block and head milling posted by Kent on April 11, 2004 at 19:54:49:
Kent, I'm not familiar with that specific engine, but whenever decks or heads or milled, I ask the shop to do what we call a "skim cut"--that's only the amount needed to insure a flat surface. This process also makes for a good gasket seal too. Any cuts on either the deck (block) or the head will result in a slightly smaller combustion chamber and therefore, a little more compression. I don't know valve/piston clearance on that engine, but if you have any doubts about adequate clearance, this should be checked before running the engine. Usually this is not a problem though, but I wanted to mention it since I haven't built that particular engine before. If that block uses sleeves, you should also confirm how the sleeve height will work if the parts are milled. If so, you may have to take a cut on the sleeves too. The engine shop should be able to tell you that once they get all the parts on hand.
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|