Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Clutch adjustment on H--almost out
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by riverbend on March 19, 2004 at 17:10:01 from (208.160.33.178):
In Reply to: Re: Re: Clutch adjustment on H--almost out posted by Jim Maine on March 19, 2004 at 13:56:26:
The adjustment screws probably will get the fingers to 2 5/32", but that will move them away from the throwout bearing, making matters worse. So in addition to that, I would guess that something else is wrong. The throwout bearing should sit 3/16" from the face of the fingers. It looks like the inner face of the clutch cover should be 27/32" from the face of the pressure plate. On my H the arm on the clutch release shaft points straight down (new pressure plate, 2 yr old disk). The length of the clutch operating rod (from center to center, pedal to arm) is 31 1/2". Are the heavy washers that hold the release yoke to the cross shaft in place ? Is your release yoke bent ?
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|