Farmall & IHC Tractors Discussion Board |
Re: What valve config for new 3pt
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dan on March 09, 2004 at 06:49:34 from (12.160.163.182):
In Reply to: What valve config for new 3pt posted by MM on March 09, 2004 at 06:35:59:
When I got my 2 spool valve I debated on a float position for the second one. I pull an offset disc with wheels and hydraulic cylinder lift. The float position would probably work ok there when running it all the way down. Think you are wise to get a 2 spool valve when doing it as it is easier than to add on later. I do not use the down pressure on my 3 point much. Have used it with cultivator and disc in harder ground but just tends to take the weight off the rear wheels. On my 3 point I can pull the 2 pins, drop the 3 point and replace the pins so that the cylinder lifts against them. It lifts higher that way. Most implements are made to pull themselves into the ground if conditions are right. sometimes down pressure can cause breakage or bending. There are tmes wehn down pressure on a rear blade may help but if you take the weight off your rear wheels you can't pull it anyway. One thing it does help with is keeping an implement at a set height as it won't move up or down.
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|