Farmall & IHC Tractors Discussion Board |
Re: Re: Where to get governor parts?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by SAm in NS on January 05, 2004 at 10:42:27 from (129.173.133.72):
In Reply to: Re: Where to get governor parts? posted by gauger on January 05, 2004 at 10:25:48:
So far as I can tell the only things that need replacing are the springs, everything else is just fine (virtually non-existent slop and smooth operation without being too stiff). After cleaning out the water everthing was covered in a white oily layer of water mixed with the oil and after cleaning (with degreaser) the inside was clean and pretty well rust free. I'll replace the springs and see where that gets me, if it still doesn't work I'll take off again then. Thanks, SAm in NS
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|