Farmall & IHC Tractors Discussion Board |
Re: I bought that 300 utility
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by dick on November 26, 2003 at 09:39:05 from (209.245.11.222):
In Reply to: I bought that 300 utility posted by Bill B on November 25, 2003 at 14:17:06:
CNKS is correct, it's like the 300RC. There is a set screw on the flange on the upper fan belt pulley which you'll have to loosen, and then you screw the pulley out to loosen the belt enough to remove it. The sides of the pulley are two different pieces which move apart to loosen the belt, and vice versa. Probably this is going to require some penetrating oil since it sounds as though all this stuff hasn't been adjusted for quite some time. This may not be a lot of fun. I'd strongly suggest you spend a few bucks on the Operators Manual. The Service Manual set and the Parts Manual are extremely useful if you're planning on doing maintenance yourself. Binder Books supplies very good reprints of the IH originals; some of the other vendors are greatly inferior. Welcome to the 300U club.
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|