Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Not sure if my tractor is a 400 or 450
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on November 20, 2003 at 12:53:02 from (64.228.11.163):
In Reply to: Re: Re: Not sure if my tractor is a 400 or 450 posted by Guy Fay on November 19, 2003 at 14:33:49:
Guy: I am not going to argue with you, however there is not the slightest sign on a letter in the casting codes of my 130 or 140. I waited until today in good daylight and used a knife and wire brush. My Super A is serial number 336977 making it a 1953 and the engine block, torque tube, transmission case and touch control are all clearly marked X. My Farmall 130 is serial number 9313 J making it a 1958 There is not the slightest resemblance of a C or a D on any of those codes. My Farmall 140 is serial number 22157 J making it a 1963. Again there is not a sign of any letters. There are quite clearly numbers in these casting codes, and everyone of those numbers are legible. There was a discussion on here some time ago, and I do forget the title, but some of the participants suggested letters were not used beyond the 100, 200, 300 and 400. My two tractors not having letters I accepted this as being so. I am 62 years of age still have 20-20 vission but do use reading glasses, for close up. I invite you to send anyone here to check this out. There are a couple of regular YT posters within 30 miles.
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|