Farmall & IHC Tractors Discussion Board |
Re: Re: Axle Paint
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dr.EVIL on September 09, 2003 at 08:40:12 from (12.4.181.2):
In Reply to: Re: Axle Paint posted by Bud on September 09, 2003 at 06:03:37:
I worked at FARMALL from 1976 till the end of 1981. Large cardboard tubes were slid over the bar axles before the main chassis of the tractor was put thru the paint booth on the main line. Tractors were then hung by hooks from a ceiling mounted conveyor system in what was called "The Repair Loop" After inspections, tests, and/or repairs and adjustments were done the tractor went down the FINISH Assembly line. Ken Updike's book "The Number Series, 1955-1985" has pics of this line during 706/806 production, maybe even 460/560 too, been a while since I re-read it for the Umteenth time. Front wheels with tires mounted and front hubs installed and rear wheels with tires & rims attached to cast centers were installed as the last thing before the tractors were ready to drive outside under their own power. So to confirm what EVERYONE else has said, FARMALL never painted the bar axles. If We did, We're sorry... And We promise to Never Ever Let it Happen again! ;-)
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|