Farmall & IHC Tractors Discussion Board |
Re: Farmall M 12 volt generator conversion wiring
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by steve on August 14, 2003 at 18:43:19 from (204.246.222.44):
In Reply to: Farmall M 12 volt generator conversion wiring diag posted by DAVE on August 14, 2003 at 13:24:16:
biggest problems found with poor charging generators are bad grounds on the voltage regulator. You voltage regulator has 3 or 4 terminals. The "G" and "F" go to the two terminals on the generator. The "B" goes to the battery, (normally the ampmeter). IF you have a "L" terminal this is normally routed to the light switch or key switch and is HOT when running. IF you dont have the "L", then the "B" terminal is taking care of both. On a 6 volt system you have the light switch controlling the "F" terminal and acting as current regulator. THe light switch on a 12 volt system is normally not used in this fashion as the current regulator is part of the voltage regulator box. Again, clean the wires and make sure the regulator is proplerly grounded to get good charge.
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|