Farmall & IHC Tractors Discussion Board |
Re: Re: Re: clutch clearance question
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JB on August 11, 2003 at 18:03:51 from (24.157.143.182):
In Reply to: Re: Re: clutch clearance question posted by Diana on August 10, 2003 at 16:36:57:
Hi, it has been 40 years since I worked on 300U. I believe there was an inspection hole on the bottom of the bell howsing/torque tube that would allow you to see the pressure plate/release bearing. With the tractor idling and in neutral and brakes locked you should be able to see if the release bearing is turning or not. Is there grease fittings on the release bearing carrier assembly or has my memory of 300U become muddled with JD 420 that we owned at the same time ? Great tractor the 300U, would pull a 17 tooth spring tooth harrow in heavy soil in 4th direct drive. The only down fall was the small gas tank and you had to fill it 3 times a day. JB
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|