Farmall & IHC Tractors Discussion Board |
sheet metal question, exhaust pipe hole
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by bill on August 03, 2003 at 06:52:29 from (65.145.104.86):
the exhaust pipe hole on my H is not completely round. description: there is a cut in the shape of a half cirlce about 2" out from the hole. there are also two small cuts in it about 1/4" L x 1/8" W. THEORY: the old muffler was sitting on the top of the sheetmetal and rubbed a hole in it. QUESTION: should the exhaust hole in the sheetmetall be perfectly round?, or are there supposed to be two notches in it? should i just weld it up? thanks for looking, and i apologize for these elementary questions.
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|