Farmall & IHC Tractors Discussion Board |
C head gasket
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by CNKS on December 17, 2002 at 10:08:15 from (207.178.96.212):
Ordered a "valve grinding" set of gaskets, part # 354474R96, consisting of a head gasket, and valve cover, manifold, and upper radiator hose fitting gaskets. Old head gasket has the original IH part number and is metal on both sides. New head gasket is metal on the block side and composite? on the head side. Came with 2 circular inserts that appear to fit in the holes for the push rods. Old gasket has 8, or one for each push rod. Did Case/IH screw up when they packaged it, if not in which holes do the inserts go? -- It will be a very tight fit if I can get them in. Will there be a problem if no inserts are used? Old gasket appears to be of much higher quality.
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|