Farmall & IHC Tractors Discussion Board |
Maybe I am nuts but I think I could make my own tractor for $5K
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by KURT on December 10, 2002 at 16:33:11 from (65.56.190.111):
For the last several days I have been mulling over a small tractor design in my head. I have thought of making a steel C-channel frame and using a 20 or 25 HP engine to drive a hydraulic pump and then use all the needed valves and use hydraulic motors for the rear drive wheels. I would have an enormous amount of thought and engineering to put into it but on a direct cost I am pretty sure I can do this for under $5,000. You may have seen those kit cars where you get a 20HP VW engine and basically weld up a roll cage and you have a souped up go cart. But think of using a hydraulic system to do the same thing only instead of built for speed it would be built for torque. What do you guys think, should I go ahead and start designing it or say screw it.? It would be all hydraulic.
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|