Farmall & IHC Tractors Discussion Board |
I should'a looked closer!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob in SE Nebraska on September 14, 2002 at 18:46:52 from (162.40.71.185):
I am finishing up my 400 and attempting to stop oil leaks. I decided the gasket between the top of the transmission and the gearbox for the belt drive was leaking. I removed the tinwork, steering wheel/ shaft assembly, fuel tank, and managed to get wiring out of the way and pulled the gearbox. I did a very careful job getting a good seal and put everything back together and cleaned everything well so I could make sure the leak was gone. After running the tractor, sure enough a spot of oil was developing but after all that work I found out the problem had been a bad pipe connection for the hydraulic couplers which is located above the belt pulley gearbox. It was a five minute job to fix the leak that took much longer than that to accomplish. At least it wasn't like I made a mistake that cost lots of money to fix. Had a great day working on the tractor anyway! Bob
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|