Farmall & IHC Tractors Discussion Board |
656 TA linkage
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dan on August 27, 2002 at 21:16:51 from (12.18.160.198):
Borrowed a neighbor's 656 d over the weekend, TA would work if you could move handle back and forth, 2 hand or harder job. Seems to be rusted or just seized up where shaft from handle goes through dash casting. Eventually the end of the shaft twisted off. Any idea where I might find a replacement part? It is sn 7867 S, ta engagement arm is located at lower left corner of the dash, the part I need is a shaft with splines on the TA arm end and a flat lever on the other side. Looks like it will push inward, left to right with some force to change but if anyone has taken one out let me know, also a source of the part and the name if possible. thanks in advance
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|