Farmall & IHC Tractors Discussion Board |
Need help with Super C please!!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by SuperCmore on July 17, 2002 at 15:05:18 from (216.138.15.82):
After installing new points, condenser, plugs, plug wires, coil, rotor, distributor cap AND having the carb rebuilt with new kit, old Cmore still has to be pulled to start. Runs fine once you pull it, but, if you slow it down below 1/2 throttle it dies and has to be pulled to start again. The starter turns the engine over just fine and plenty fast...just won't start unless it's pulled. What, oh what could be wrong with Cmore?? I took off the glass sediment bowl and cleaned...plenty of gas to carb...could new rebuilt carb be set wrong?? Thanks for any help...SuperCmore
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|