Farmall & IHC Tractors Discussion Board |
bull/pinion grease seal
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by obie NH on May 25, 2002 at 10:51:32 from (152.163.204.83):
I was replaceing the brakes on my 39 H,and as you could suspect the grease seals on both sides were leaking badly.I ordered some aftermarket seals and while waiting for them started to remove the old ones.Every seal I ever dealt with on cars or big trucks go directly into the steel casting.So as I was destroying these seals to remove them I notice not was I only destroying the seal but also a piece around them which is call the seal ring.Will this ring come out of the casting?is this a part which you can get from IH ?Or does the new seal go in without the seal ring?Hope I did not make a whole lot of extra work by not doing this the correct way.Thanks Obie in NH
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|