Farmall & IHC Tractors Discussion Board |
400 project
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by donwisc on April 25, 2002 at 15:32:40 from (63.155.248.207):
I poste earlier this year aboutn a 400 I bought. Finally the weather has improved and I got home to work on it. You guys gave me some good info on lack of power and front end shimmy. The power problem was due to the last guy who went into the govenor tightened up a bolt on the connector rod to the throttle shaft so hard that the rod would only swivel in one direction. This put everything in a bind. Now I get a response on every notch and no lack of power. Once all the tin was off I found the steering shaft universal was almost completely gone. This was replaced and did improve the situation but not completly. I know the tires are mis matched and Ill get this corrected before I get in to the front bolster bushings. The situation I have now is on the LH axle seals. It started leaking after I run the tractor around a bit. Replacing the seal is not too big a job so I loosened up the retainer to see how much oil would come out. Well since yesterday about 1 gal has dripped / poured out. I notice that the tranny level check plug is acually above the bottom of the axle shaft so I am literally draining the transmission down past the level plug. Any thoughts on this, could the tranny level be lowered some without damage to reduction gears?
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|