Farmall & IHC Tractors Discussion Board |
Culti vision A update.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Brian on April 14, 2002 at 17:50:36 from (66.185.84.197):
Proceeded to start up the culti vision A today. Poured some gas down the cylinders. She started right up, then died. No problem.... Went to start it again... and nothing.... won't seem to turn over... hummmm.... thouht I'd try turning the motor over by rotating the PTO, couldn't do it. So... thought to my self....better take the inspection plate off and see if I could pry on the ring gear teeth to get her to turn. Well I should have known.... I took off the plate and sure enough... there was a mouse nest there grrrr. I still wasn't sure why it wouldn't turn over, so I proceeded to take the starter off, and there it was. The mouse crap had wound up in all the gears. Took me half an hour to clean it up, then she turned over much more freely and started right up. The motor isn't running very well yet, I had to adjust the choke alot depending on the throttle position to keep her running. I will be looking in the achives for advice. Still have to take her off the blocks, fill the crank case oil. Also have to freaking redo the pump for the loader's hydraulics...grrrrrrr Anyway.. thought you all would like to hear an update. Thanks. Brian.
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|