Farmall & IHC Tractors Discussion Board |
C Touch Control
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Charles Norwood on February 25, 2002 at 20:01:28 from (207.178.96.214):
I have a Farmall C and Super A. I put a Saginaw 3 point hitch on the C, changed the fluid and refilled to the bottom of the filler hole--with the touch control levers to the rear as instructed. The C has a vent in the filler plug and fluid comes out the vent. I just purchased the tractor and have not used it, but I don't think I lost fluid before I installed the hitch --just cycled it a few times to see if it worked. My Super A does not have the vent. I thought both systems were closed systems. Is the C system supposed to be vented or not? Fluid level is now well below the filler neck and it is still pushed out the vent. It leaks some from the control valves below the rockshaft in front of the unit. I plan to disassemble it and replace the seals. I have no idea if this will prevent fluid loss out the vent. If I use a plug with no vent, will this damage the unit or cause my new seals to leak? I have a parts book for the Super A but not the C and am not sure of the differences, if any. Thanks in advance for your help.
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|