Farmall & IHC Tractors Discussion Board |
Hydraulic problem 460 Mc -Farmall
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by ol Chief on June 05, 2007 at 19:12:33 from (69.91.92.199):
I am having a constant hydraulic overload on the engine. The only way to relieve the engine load is to operate the hydraulic system. On two previous occasions I cured the situation by removing the valve block and cleaning the tiny 300 mesh screen which is fitted to the small ball check valve.I have mislaid my shop manual,so no longer have a trouble shooting guide.I noted that the small pin to prevent loss of the tiny ball bearing was missing so I fitted a new retaining pin.However I do not know if there is a spring required to seat the ball.If so then it has been lost.I just finished this chore and test ran the tractor. I still have the same overload.I am hoping someone can help out on this problem. Thanx
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|