Farmall & IHC Tractors Discussion Board |
Reply to Allan. A role model for many.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Huss on May 22, 2007 at 05:16:53 from (58.178.118.50):
In Reply to: Re: URGENT HELP PLEASE, IH 756 posted by Allan In NE on May 22, 2007 at 03:44:18:
Hi Allen, As always you take the time to help other, You are a role model for many. Thank you for your reply. I havnt checked the pressure as I had replaced the 12gpm pump with a new 17gpm pump and assumed it was fine. I guess not will look at that tomorrw. Will also do the same with the regulator. It is actually lifting fine. The problem is that if i want to raise the position lever any more it is not just a matter of pulling it up a inch or two. I have to lower the raise position lever all the way back down and start to pull it up again. This is the problem. Thank you again Huss
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|