Farmall & IHC Tractors Discussion Board |
Re: 826 problem.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by K.B.-826 on May 21, 2007 at 17:33:34 from (24.180.143.209):
In Reply to: 826 problem. posted by Bradford on May 20, 2007 at 20:38:29:
I hate to be the bearer of bad news, but two tablespoons of water is two too many. It really dosen't matter if you've got straight water or antifreeze in the radiator, oil and water do not mix. As soon as some of that water gets sucked up by the oil pump and fed to a bearing, its gonna push the oil off of the bearing, heat will build, and bearing will become welded to crankshaft. Once a bearing starts spinning, there's no telling what will get wrecked. If you're lucky, it'll be a rod bearing and only wreck a rod and the crankshaft. If it's a main, then you get to buy a crank and a block. There aren't a whole lot of 358 blocks around anymore.
Replies:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|