Farmall & IHC Tractors Discussion Board |
Farmall 450 LP engine speed control
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Albert Pereira on May 05, 2007 at 20:43:13 from (205.188.116.138):
Hello, I just purchased a Farmall 450 on LP the speed control lever needs to be at full throtle just to idle and start the tractor, and almost straight down to idle up enough to drie and pull a little. The linkage is by no means new, but there is not that much play in it. I diconected it from the governor that throtled it up it was a little better but not much. Is there an adjustment to increase the engine speed in the governor or on the regulator or carb. Please help this is my first LP tractor and have no expereince on them. Also is there a place that sells the little gasket at the bottom of the three hydro levers there are four bolts and it bolts to the bottom of the hydro controls. Thanks
Replies:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|