Farmall & IHC Tractors Discussion Board |
Re: Looking for painting advice
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by PaulW_NJ on May 05, 2007 at 19:00:23 from (70.111.87.67):
In Reply to: Looking for painting advice posted by Tom Windsor on May 05, 2007 at 18:37:12:
Tom There is a great deal of excellent material on the Painting and Bodywork forum of this same site. I"ve used such procedures on pitted metal and it has worked extremely well. Here"s one example. An important element of dealing with pitted metal is to eliminate rust inside the pits. Otherwise corrosion will continue under the new surface you apply. If you are not sandblasting or using electrolysis, at least treat the sanded sheetmetal with a phosphoric acid based rust converter such as Picklex or Must for Rust. Epoxy primer followed by body glaze or body putty followed by primer surfacer will eleminate those pits completely so when you topcoat you will achieve a smooth surface.
Replies:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|