Farmall & IHC Tractors Discussion Board |
Re: H steering worm gear
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by chuck46 on March 03, 2007 at 20:14:43 from (64.136.27.229):
In Reply to: H steering worm gear posted by Gary Puckett on March 03, 2007 at 18:06:13:
Hi, You can not turn the gear over because the spline it sets on is tapered, make sure the trust bearing and bushings on the upper bolster shaft are good, also the ball bearing and bushings on the steering shaft. Use a jack under the frame rails to check for vertical play on the bolster, use shim washers under the gear if you can. If this doesn't give you a good fit then look for another gear. Good luck, Chuck
Replies:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|